Fittings catalogue 2021

5.41 www.demos ‑trade.com 284545 284546 284551 284547 284549 284550 F I T T I N G S F O R S L I D I N G A N D F O L D I N G D O O R S sliding inset cabinet doors Ĺ Optimum weights for each type of panel can be found on page 5.3. Strong LINIO min. 18 mm ball bearings load 40 kg code description set for 2 leaves, 4 × damper set for 3 leaves, 4 × damper code description for a 3-leaf set code length (m) 1.5 2 3 • elegant solution for inset doors • guide milled into the cabinet body, min. thickness 18 mm • quiet running, high-quality bearings for long life service • damping hidden in guide for silent closing of the leaf • simple regulation, safety latch for easier leaf installation • the set includes trolleys in the appropriate quantity, guide end pieces, connecting material and hex key • for centre damper mounting, the middle leaf must be in the rear or the gap between the leaves must be enlarged to allow other leaves into move • centre damper should be mounted to the cabinet body, guiding pin on leaf • surface treatment – anodised silver bottom guide n Mounting information: 1. Before inserting the guide into the cabinet body, insert dampers and end pieces to the rail. Please mind the correct orientation of the damper – arrows must point to the cabinet body centre. 2. Draw dampers in the working position (according to the arrow – towards the cabinet body centre). 3. Before installing the leaf, push top trolleys in installation position and secure them with a safety latch. 4. Insert the leaf into the bottom rail, then direct the top trolley to the top rail and release the safety latch. 5. Warning – leaf deflection during installation must not exceed 20°, otherwise the guide or even the cabinet body may suffer damage. 6. Regulate the leaf position, then secure against unhooking by tightening the top trolley. 7. Align and secure the position of dampers to close the door to the cabinet body side properly. Top/bottom guide Centre damper CONTENTS