Fittings catalogue 2021

10.22 12345 12345 10 405177 4 × 10 406053 8 × 16 405478 405477 406055 406054 284616 18W, 0.75 A 1.5 284617 30 W, 1.25 A 2.5 284618 60 W, 2.5 A 5 284619 80 W, 3.4 A 6,6 3] 284620 120W, 5 A 10 3] 4 10 8 5,8 0,9 2,3 23.79 10:1 N041 0B MATERIA L WEIGHT (g): A4 SCALE: DRAWING NUMBER: NAME: DATE DRAWN SMEJA I SO 2768 03.04.2020 A A B B C C D D E E F F 4 4 3 3 2 2 1 1 8 10,6 16 102.17 5:1 N0816B MATERIAL WEIGHT (g): A4 SCALE: DRAWING NUMBER: NAME: DATE DRAWN SMEJA ISO 2768 03.04.2020 A A B B C C D D E E F F 4 4 3 3 2 2 1 1 F U R N I T U R E L I G H T S Item in stock Item on demand LED strips, 24 V Ĺ Observe necessary work rules for sensitive electronics, for detailed information see p. 10.5. Tips for use: • suitable as outdoor and indoor decoration • classic neon effect • can be used as illuminated advertising, etc. Input power: 10 W/m, Silicone (Neon effect) LED strip IP 67 (after sealing) • maximum length of continuous strip: 5 m • coil: 5 m • 1.5 m cables on both sides with Mini connectors • in neutral white • in a narrow profile it is possible to bend it with a radius of 35 mm, it must not bend transversely, or twisted, bend over a sharp corner, etc. • for water resistance, the ends must be covered with the appropriate end pieces and the connection must be sealed with silicone sealant • inside the groove of the silicone cover, there is a pre-installed string for threading the LED strip through • LED strips 12/24 V with lower power from our offer can be used • not suitable for LED strips with power over 10 W/m because of poor heat dissipation • RGB LED strips can also be used – white colour, however, can result in overheating and damage to the LED strip and the silicone cover code type dimension (mm) with 10 W/m LED strip, neutral white without LED strip (recommended width of LED strip: 8–10 mm) code description end piece for silicone (Neon effect) LED strip – with hole for cables end piece for silicone (Neon effect) LED strip – without hole end piece for silicone (Neon effect) cover (without LED strip) – with hole for cables end piece for silicone (Neon effect) cover (without LED strip) – without hole For the proper operation of LED strips, it is important to place it in an aluminium profile with a cover. 2] To calculate the power, multiply the length of the LED strip by its input power per meter. In case of a long-term load, we recommend increasing the power reserve. Ĺ For further types of 24 V transformers, see p. 10.27. 3] Do not exceed the maximum recommended length of the LED strips. If necessary, divide them into multiple parts and power them using multiple supply cables. Longer lines can be powered from both ends. RECOMMENDED TRANSFORMERS (FOR CODE 405177) 2] code power maximum length of LED strip (m) ACCESSORIES CONTENTS 1 2 3 4 5 6 7 8 9 11 12 13 14 15