07.17 www.demos‑trade.com 10 max. 20°! !!! 15 15 min. 7 h = H - 12 H 12 12 135 135 60 60 R12 R12 49 49 12 12 10 max. 20°! !!! 135 135 60 60 R12 R12 49 49 12 12 284545 284546 284551 284547 1,5 284549 2 284550 3 FITTINGS FOR SLIDING AND FOLDING DOORS, WARDROBE EQUIPMENT sliding inset cabinet doors dimensional diagram min. 18 mm ball bearings load 40 kg • elegant solution for inset doors • guide milled into the cabinet body, min. thickness 18 mm • quiet running, high-quality bearings for long life service • soft closing hidden in guide for silent closing of the leaf • easy adjustment, safety latch for easier leaf installation • the kit includes the appropriate number of runners, guide end pieces, fixing materials and hex key • minimum leaf width is 600 mm • for centre soft closer mounting, the centre leaf must be at the back or the gap between the leaves must be increased to allow the other leaves to move • centre soft closer should be mounted to the cabinet body, guiding pin on the leaf bottom guide n Mounting information: 1. Before inserting the guide into the cabinet body, insert soft closer and end pieces to the rail.Note the correct orientation of the soft closer - the arrows must point to the centre of the cabinet body. 2. Pull the soft closer into the working position (as indicated by the arrow - towards the centre of the cabinet). 3. Before installing the leaf, push top runners components in installation position and secure them with a safety latch. 4. Insert the leaf into the bottom rail, then direct the top runner component to the top rail and release the safety latch. 5. Warning - Do not allow the leaf to deflect more than 20° during installation, as this may damage the guide or even the cabinet body! 6. Regulate the leaf position, then secure against unhooking by tightening the top runner component. 7. Adjust and secure the soft close position to ensure that the door closes properly towards the cabinet body. StrongLine LINIO Centre soft closer code description set for 2 leaves, 4× soft closer set for 3 leaves, 4× soft closer code description for a 3-leaf set • surface treatment – anodised silver Top/bottom guide code length (m) hole for the top runner component hole for the bottom runner component use of the end pieces of the guide profile correct orientation of the soft closer in the guide profile leaf deployment and adjustment
RkJQdWJsaXNoZXIy MzEyMDA=