01.31 www.demos‑trade.com min. 86 67 3-7 9 19 RS 37 16,5 0,7 21 min. 70 33,5 21,5 F 8 3-7 51 12042 70T3504 12093 70.1503 12319 16 mm 6 mm 12341 19 mm 3 mm 12340 22 mm 0 mm 203405 79B9950 12083 79T9950 118122 79B9550 13070 79T9550 12079 79T958E 166071 78T9550.TL CLIP top blind corner FURNITURE HINGES code thickness of the cabinet body frame (FS) raising of mounting plates motion code Blum code cup mounting with BLUMOTION screw with spring screw motion code Blum code cup mounting with BLUMOTION screw with spring screw EXPANDO TIP-ON screw code Blum code description cups arms • hinges with and without soft closing cannot be combined • the plate for the full overlay hinge is dependent on the strength of the cabinet body material – see the table • the plate for inset hinges should be raised by 3 mm – e.g. 12341, 12303 • drilling depth for a cup 13 mm (12.3 mm without soft closing) • cup diameter 35 mm • minimum inner dimension of blind corner, door 70 mm (inset), 86 mm (full overlay) • 95° opening angle • door thickness from 16 to 28 mm • option to offset the cup 3 to 7 mm from the edge • drilling a hole for EXPANDO 45 / 9.5 mm pitch / 8 mm diameter • for further information, see the Blum catalogue gap Plates for blind corner hinge (full overlay) Full overlay Cover caps Inset
RkJQdWJsaXNoZXIy MzEyMDA=